CAUTION & TIPS

Do not apply sealer in hot sunlight.

Do not pre-seal the tiles before laying.

Do not seal damp tiles, and do not allow water to lie on the surface of the sealed tile for at least 3 days after sealing with Deep Seal. If water falls on the surface before the Deep Seal has cured properly, wipe it up immediately with a dry cloth otherwise white marks may occur. These marks may sometimes be removed with a little Xylene on a rag, but only if they are less than 6 hours old.

Clean equipment with Xylene before the sealer has dried.

Maintain the floor by cleaning DAILY with Tile & Floor Care Quick Clean.

BLOTCHED OR STREAKY EFFECTS

If streakiness appears after sealing, this is usually due to one of the following:

The tiles were not cleaned properly before sealing. PLEASE MAKE SURE THAT THE TILES ARE CLEAN BEFORE SEALING!

To much sealer was applied. The shiny areas will usually matt down after a little foot traffics, but it the application was particularly bad, the streaks may be evened out by rubbing down with some Xylene within 6 hours of application of the Deep Seal.